Setup Guide
Setup Guide
Step 1: Run Setup.exe
Run Setup.exe and go through the installation process. This installs dependencies (like DirectX) and sets paths for MAMEHooker based on its location, since MAMEHooker has trouble using relative paths.
[[File:Setup.gif|thumb|left|900px|
Step 1.a: Choose a Drive Letter
This build uses almost all relative paths, so the drive letter does not matter. Choose a drive letter or use the letter that Windows assigned to the drive.
Step 1.b: Place the Build on the Root of Your Drive
If your build is on drive H:, for example the paths should look exactly as they do below:
H:\Launchbox H:\Tools
If this step is skipped, the build will not work correctly. This is very important.
Step 2: MAMEHooker / Hook Of The Reaper Setup
Step 2.a: COM Port Setup
Set COM ports for all players based on gun type using the COM Port Assignment List below.
- Open Device Manager
- Expand Ports (COM & LPT)
- Right-click each device → Properties → Port Settings → Advanced
- Assign COM ports as follows.
- If you have trouble identifying Player 1 and Player 2 under (COM & LPT), unplug the guns and plug them back in one at a time; the correct device will disappear/reappear.
COM Port Assignment List
- OpenFire
- Gun 1 → COM1
- Gun 2 → COM2
- Blancom
- Gun 1 → COM1
- Gun 2 → COM2
- Gun4IR
- Gun 1 → COM1
- Gun 2 → COM2
- XGunner
- Gun 1 → COM1
- Gun 2 → COM2
- MX24
- Gun 1 & 2 → COM5 (Hub)
- RS3 Reaper
- Hub → COM5
- Gun 1 → COM6
- Gun 2 → COM7
- Gun 3 → COM8
- Gun 4 → COM9
- Turn off recoil switch (set slider to the middle)